Dry-mixed mortar is currently a new type of environmentally friendly building material, and its superior product performance has been widely recognized. It is a revolutionary change compared to traditional building materials and construction methods. It will surely make a qualitative leap in the construction and use of our country.

Dry mortar is produced from a variety of materials, according to different formulations and corresponding process methods according to different purposes. Among them, according to the process requirements and the proportion of the formulation of various materials, accurate dosing is the key to ensure the quality of the product and the normal operation of the production line. On the basis of the introduction of foreign advanced technology, we have long studied the characteristics of various materials, accumulated a wealth of practical experience, and solved the problem of fast and accurate ingredients.

Design points for measuring batching bins:

Under the premise of ensuring sufficient rigidity (especially the load cell installation and support part), the weight of the metering bin system should be as light as possible; its effective volume is 110-120% of the total sum of the volume of various formula materials; Designed according to the angle where the material with the least fluidity can slide freely and smoothly. If the design of the cone angle is too small, it is easy to appear that the material in the warehouse is not clean, and the meter display does not return to zero and cannot automatically enter the stop state of the next step, which causes the automatic production line to be interrupted. For materials with very poor fluidity, several sets of one-way air nozzles can be provided in the middle and lower parts of the silo; flexible silos can also be used; in order to reduce frictional resistance and improve corrosion resistance, a design can be easily replaced. Stainless steel lining; the connection part of the metering bin and the load cell should have height adjustment, limit position and pre-supporting device; 3 load cells must be symmetrically distributed to balance the force; One adds rigidity, while the calibration weight is placed for calibration.